The Adapta-Stack is a fully assembled, tested, and ready for use flow battery!  Only a flathead screwdriver and torque wrench are necessary to assemble the Adapta-Stack so you can concentrate on creating your very own powered applications.

✔ Endplates with Push-to-Connect Fittings
✔ Carbon Cloth
✔ Wetted PVC and CPVC
✔ Parallel Flow Fields
✔ Wetted Vinyl Ester
✔ Hardware

• Electrode Area: 10 cm²
• Ports: 4
• Flow Rate: 10 to 80 cc/minute at 1 Amp 1 Volt for charging
• For Charging: 1 Amp / 1 Volt
• Liquid is fed into the bottom and out the top.
• Dimensions: 3.25" x 3.25" x 2" (8.26 x 8.26 x 5.1 cm)
• Recommended Torque Value: 8-10 inlbs

The Flow Battery Adapta-Stack's flow rate should be started at 10 cc per minute and go up to 100 cc per minute. The overall flow rate will be determined by the state of charge of the electrolyte.

When your Flow Battery has a charged electrolyte inside of it, you can then tell which side is positive and which side is negative. When charging the Flow Battery make sure that the liquid is fed into the bottom and out the top.

Please note that the Flow Battery Adapta-Stack does not come with guide dowels.  1/8" guide dowels are recommended for assembly of the stack to aid in the alignment of the components.